Example 2: Procedure To Set An Operation; Description Of The Exercise; Procedure - GE Multilin G650 Manual

10 APPLICATION EXAMPLES

10.2EXAMPLE 2: PROCEDURE TO SET AN OPERATION

This simple operation describes how to program and set an operation command on the G650 relay. In the present case the
operation is:
To configure some G650 output contact to be operated since the front of the relay.
To set some LED to show the operation of the output contact (while being closed).
To close a G650 output contact using a front key pushbutton.
To reset the output contact and LED using another front key pushbutton.
Set the following values:
Under
SETPOINT ⇓ CONTROL ELEMENTS ⇒ INPUTS/OUTPUTS ⇒ BOARD F
* This setting is non-relevant since it applies only when "pulse" type is chosen
Under
SETPOINT ⇓ RELAY CONFIGURATION ⇒ OUTPUTS
SELECT
Contact Output Operate 00 (Board F)
Contact Output Reset 00 (Board F)
Under
SETPOINT ⇓ RELAY CONFIGURATION ⇒ LEDS
GEK-113285A
NAME
Output Logic_00_00
Output Type_00_00
Pulse Output Time
SELECT NAME
Close Contact_00_00
Led 14
G650 Generator Protection & Control System
10.2 EXAMPLE 2: PROCEDURE TO SET AN OPERATION

10.2.1 DESCRIPTION OF THE EXERCISE

VALUE
Positive
Latch
10000ms *
NAME
C_Output Oper_00_00
C_Output Reset_00_00
SOURCE
C_Output_00_00

10.2.2 PROCEDURE

SOURCE
Operation_bit000
Operation_bit001
10-5
10