CONNECTING ENERVISTA MM300 SETUP TO THE RELAY
Upgrading the software
Connecting EnerVista MM300 Setup to the relay
Configuring serial communications
32
Select USB as the Interface type.
14. Select the appropriate USB device.
The latest EnerVista software and firmware can be downloaded from:
https://www.gegridsolutions.com/app/ViewFiles.aspx?prod=mm300&type=7
After upgrading, check the version number under Help > About. If the new version does
not display, try uninstalling the software and reinstalling the new versions.
Before starting, verify that the cable is properly connected to either the USB port on the
front panel of the device (for USB communications) or to the Serial port on the rear of the
device. This example demonstrates a Serial connection.
1.
Install and start the latest version of the EnerVista MM300/MM200 Setup software
(available from the GE Multilin web site). See the previous section for the installation
procedure.
2.
Click on the Device Setup button to open the Device Setup window and click the Add
Site button to define a new site.
3.
Enter the desired site name in the "Site Name" field. If desired, a short description of
the site can also be entered. In this example, we will use "New Site 1" as the site name.
4.
The new site will appear in the upper-left list in the EnerVista MM300/MM200
Setup window.
5.
Click the Add Device button to define the new device.
6.
Enter the desired name in the "Device Name" field and a description (optional) of the
device.
7.
Select "Serial Device" from the Interface drop-down list.
MM300 MOTOR MANAGEMENT SYSTEM – QUICKSTART GUIDE
CHAPTER 2: INSTALLATION