GE C30 Instruction Manual page 24

1.3 ENERVISTA UR SETUP SOFTWARE
3. Select the Internet Protocol (TCP/IP) item from the list, and click the Properties button.
1
4. Click the "Use the following IP address" box.
5. Enter an IP address with the first three numbers the same as the IP address of the C30 relay and the last number dif-
ferent (in this example, 1.1.1.2).
6. Enter a subnet mask equal to the one set in the C30 (in this example, 255.0.0.0).
7. Click the OK button to save the values.
Before continuing, test the Ethernet connection.
1. Open a Windows console window by selecting Start > Run from the Windows Start menu and typing "cmd".
2. Type the following command, substituting the IP address of 1.1.1.1 with yours:
C:\WINNT>ping 1.1.1.1
3. If the connection is successful, the system returns four replies similar to the following:
Pinging 1.1.1.1 with 32 bytes of data:
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Reply from 1.1.1.1: bytes=32 time<10ms TTL=255
Ping statistics for 1.1.1.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip time in milliseconds:
Minimum = 0ms, Maximum = 0ms, Average = 0 ms
4. Note that the values for
5. If the following sequence of messages appears when entering the
1-12
and vary depending on local network configuration.
time TTL
C30 Controller System
1 GETTING STARTED
command:
C:\WINNT>ping 1.1.1.1
GE Multilin