Makita 2712 Instruction Manual page 5

− Table saw (1 unit)
− Leg (4 pcs)
− Foot (4 pcs)
− Countersunk screw for foot (4 pcs)
− Hex nut for foot (4 pcs)
− Leg support (long) (2 pcs)
− Leg support (short) (2 pcs)
− Tire complete (1 pc)
− Dust nozzle (1 pc)
− Carrying handle (2 pcs)
− Square neck bolt for guide rail (4 pcs)
− Hex bolt for guide rail (4 pcs)
− Guide rail (long) (1 pc)
− Guide rail (short) (1 pc)
− Sub table (1 pc)
− Stay (long) (2 pc)
− Stay (short) (2 pc)
− Hook (1 pc)
− Blade guard (1 pct)
− Tapping screw (3 pcs)
− Hex bolt (38 pcs)
− Hex nut (38 pcs)
− Hex wrench (1 pc)
− Wrench (1 pc)
− Push stick (1 pc)
− Push block (1 pc)
− Fence (for Rip fence) (1 pc)
− Rip fence (1 pc)
Installing table saw
1. Overturn the table saw on two boards. Check the
riving knife positions the space between two
boards.
1. Board
2. Riving knife
014597
1
2
2. Attach the four legs to the inside of base edge.
Attach the leg with the hole for the switch to the side
with the sign "A "on the base. Secure the four legs
temporarily, do not tighten the screws firmly yet.
3
1. Leg
2. Switch hole
3. Sign A
014566
3. Attach the leg supports (long) to the legs and
then attach the leg supports (short) to the legs.
Secure the legs and leg supports with the screws
firmly. Always check the direction of support legs.
4. Install the feet at the bottoms of the legs. Secure
them with countersunk screws and hex nuts.
3
1
1. Leg support (long)
2. Leg support (short)
3. Foot
4. Wider side
014567
5
1
2
1
2
2
4