NEC Univerge SV9100 Manual page 354


IP Trunk – (SIP) Session Initiation Protocol:
Program
Program Name/Description
Number
10-12-03 GCD-CP10 Network Setup – Default
Gateway
Assign the default gateway IP address for the
GCD-CP10.
10-12-05 GCD-CP10 Network Setup – NIC Interface
Set up the NIC Interface.
10-12-07 GCD-CP10 Network Setup – NAPT Router IP
Address
(Default Gateway [WAN])
Define the IP Address of the WAN side of the
router.

Only used when Program 10-20-21 is enabled.
10-12-08 GCD-CP10 Network Setup – ICMP Redirect
When receiving ICMP redirect messages, this
determines if the IP Routing Table updates
automatically or not.
10-12-09 GCD-CP10 Network Setup – IP Address
Set IP address for GPZ-IPLE.
10-12-10 GCD-CP10 Network Setup – Subnet Mask
Define the Media Gateway Subnet Mask
Address.
6-8
feature.
Level 3 – these programs are not often assigned and require an expert level
working knowledge of the system to be properly assigned.
Input Data
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0 = Auto Detect
1 = 100Mbps, Full Duplex
2 = 100Mbps, Half Duplex
3 = 10Mbps, Full Duplex
4 = 10Mbps, Half Duplex
5 = 1Gbps, Full Duplex
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0= (Enable)
1= (Disable)
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
128.0.0.0 | 192.0.0.0 | 224.0.0.0
|240.0.0.0 | 248.0.0.0 | 252.0.0.0
|254.0.0.0 | 255.0.0.0
|255.128.0.0 | 255.192.0.0
|255.224.0.0 | 255.240.0.0
|255.248.0.0 | 255.252.0.0
|255.254.0.0 | 255.255.0.0
|255.255.128.0 | 255.255.192.0
|255.255.224.0 | 255.255.240.0
|255.255.248.0 | 255.255.252.0
|255.255.254.0 | 255.255.255.0
|255.255.255.128
|255.255.255.192
|255.255.255.224
|255.255.255.240
|255.255.255.248
|255.255.255.252
|255.255.255.254
|255.255.255.255
Issue 2.0
Level
Default
1 2 3
0.0.0.0

0

0.0.0.0

0

172.16.0.10

255.255.0.0

SIP Trunking