Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -4. Rotor, Stator (cont.)
DISASSEMBLING
(2) Remove Motor section as drawn in Fig. 11.
Fig. 11
1. Disconnect the connectors of DC
motor section from those of
Controller, and then remove DC
motor section together with
Gear box from Housing L.
Housing L
DC motor
section
(3) Remove Rotor from Stator as drawn in Fig. 12.
Fig. 12
4. Put Motor section on a workbench so that reverse side of the drive end of Rotor touches workbench.
Then, separate Rotor from Stator by pressing Stator down towards workbench while pulling up Rotor.
Caution for Handling of Rotor
When handling or storing multiple Rotors, be sure to provide enough
distance so that they do not draw each other.
Rotor is a strongly magnetic body.
Therefore, failure to follow this instruction could result in:
* Finger injury caused by pinching between Rotors pulling each other
* Magnetic loss of Rotors
2. Unscrew four 4x18 Tapping
screws, and separate Gear
box from DC motor section.
DC motor
Gear box
section
Workbench
3. Unscrew three 4x18 Tapping screws,
Gear box
4x18 Tapping screw
(4 pcs.)
and separate Motor housing R from
Motor housing L.
And then, remove Rotor together
with Stator from Motor housing L.
Motor housing R
4x18 Tapping
screw (3 pcs.)
Stator
Rotor
Motor housing L
enough
distance
P 8/ 13
Advertisement
