Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Head case complete (cont.)
DISASSEMBLING
(3) Disassemble Head case complete as drawn in Fig. 5.
Fig. 5
1. Lock Cutter holder with 1R308 inserted into its hole.
Hold Head case complete with vise.
Insert the modified end of Hex wrench 5 to the square
hole of Cutter shaft.
Cutter holder is removed from Head case complete by
turning Hex wrench 5 counterclockwise.
Cutter holder
1R308
Head case
complete
Modified Hex wrench 5 (See previous page.)
3. Disassemble Cutter shaft section as drawn below.
Bearing washer
Cutter shaft
ASSEMBLING
Assemble Head case complete in the reverse order of Disassembly. Refer to Fig. 5.
Be careful to the directions of Washer and Bearing washer. (Fig. 6)
Fig. 6
Spring washer 8
Cutter holder
Face the projection of Washer and Bearing washer to the opposite direction of Cutter holder.
Cutter holder
Head case complete
Ball bearing 608ZZ
Ball bearing 608DDW
Collar
Head case
Washer
2. Put Head case complete on Turn table of
Arbor press. Press Cutter shaft with 1R286.
Cutter shaft section is separated from
Head case complete.
1R286
Cutter shaft
Washer
Spring washer M8
Ball bearing 608DDW
Cutter shaft
P 5/ 13
Head case
complete
Cutter shaft
section
Collar
Ball bearing 608ZZ
Bearing washer
Advertisement
