Casio 140CR Manual page 4

10
What Is A Report?
The Cash Register has two reporting modes:
• X mode prints sales information without resetting sales data back to zero.
(Used normally at Midday to check turnover)
• Z mode prints sales information, and resets all sales data back to zero.
(Used normally at the End of Day)
How To Obtain A Daily Sales Report
• Insert the PGM key in the mode lock.
• Turn the key to either the (X position
to print without clearing sales figures).
or (Z position to print and clear sales
data back to zero).
• Press CA/AMTEND
• The report is printed listing the amount of transactions put
through each of the department buttons.
• Turn the key to the OFF, insert the OP key and turn back
to REG for normal use.
Report Type
Total In Drawer
Daily (Read)
Daily (Reset)
Periodic Accumulated (Read)
Periodic Accumulated (Reset)
!
When The Cash Drawer Does Not Open
In the event of a power failure the Cash Drawer will NOT
open. First ensure that the drawer is unlocked, then pull
the release lever on the base of the machine as illustrated
in the diagram.
!
Trouble Shooting
During the lifetime of the cash register it is possible a problem may occur during operation.
The table below illustrates how a problem can be easily rectified.
Symptom/Problem
E01 appears on the display.
E94 appears on the display.
No date or time on receipt.
Paper is not advancing enough.
Key won't turn to Z, X, PGM and RF modes.
Drawer opens up after ringing up only one time.
Not clearing totals at end of day after taking report.
Programming is lost whenever register is
unplugged or there is a power outage
Register is inoperative
Can't get money out ot drawer.
Mode Lock
CAL
REG
OFF
RF
PGM
Report Options
Key Lock Report Button Press
X
X
X
=
Z
=
X
Z
Most Common Causes
Changing modes without completing transaction.
Printer paper is jammed.
Printer is programmed as a journal.
Using OP key.
Department is programmed as a single item dept.
Using X mode to take out reports.
Bad or no batteries.
No power.
Z (Reset) report
X
Z
DATE
TIME
CA AMT
TEND
CA AMT
TEND
1 0
CA AMT
=
TEND
1 0
CA AMT
=
TEND
Solutions
Return key to where it
stops erroring and press
Remove jammed paper. Turn Mode
switch to OFF then turn to ON, or Turn
Program printer to print receipts.
Use the PGM key.
Program the dept. as a normal dept.
Use Z mode to take out reports.
Put in new batteries.
Pull lever underneath register at rear.
Date
Time/
Consecutive No.
Report Type/Counter
No. of items/
Dept. No.
Amount
Gross Sales
No. of items
Gross Sales
Amount
CA AMT
=
TEND
power OFF and then turn power ON.