Honeywell TheraPro HR90 Instruction Manual page 4

Selecting the adapter
The radiator controller fits on common radiator valves
of the type M30 x 1.5. Adapters are required for some
valve types.
1. Check whether an adapter is required and, if
necessary, select the appropriate adapter.
Brand
Honeywell-
Braukmann,
MNG, Heimeier,
Oventrop valves
M30 x 1.5
Danfoss RA
Danfoss RAV
Danfoss RAVL
2. Slide the adapter onto the radiator valve and turn it
until you feel it click into place.
3. If necessary, screw the adapter tight with a screw.
Mounting the valve baseplate
1b
1. Separate the valve baseplate from the radiator
controller. To do so, push the slide towards
Illustration Adapter
required
Supplied
Not
2. Turn the adjustment dial of the valve baseplate
counter-clockwise until it stops.
3. Put the valve baseplate onto the radiator valve or the
adapter and tighten by hand (without tools!).
Mounting the radiator controller
1. Ensure that the slide on the radiator controller is in the
open position.
2. Put the radiator controller onto the valve baseplate
so that the indentation latches in and is no longer
visible.
3. Lock the radiator controller in the end position. To do
so, push the slide towards
After approx. 1 minute
Afterwards the radiator controller changes to
automatic mode.
1a
i
The radiator controller only operates if it is locked
correctly in the end position.
FINISHED! – After mounting, the radiator controller
operates immediately in the factory setting (standard
time program), see Section 5.
.
4
3.
2.
1.
3.
2.
.
(self-test) is displayed.
cycl