Functional Description - Makita 3710 Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting bit protrusion
5
006631
To adjust the bit protrusion, loosen the clamping nut and
move the tool base up or down as desired by turning the
adjusting screw. After adjusting, tighten the clamping nut
firmly to secure the tool base.
Adjusting angle of tool base
1
2
3
5
4
006632
Loosen the wing bolts and adjust the angle of the tool
base (5° per graduation) to obtain the desired cutting
angle.
Adjusting amount of chamfering
To adjust the amount of chamfering, loosen the wing
nuts and adjust the trimmer shoe.
CAUTION:
With the tool unplugged and switch in the "OFF"
•
position, rotate the collet nut on the tool several
times to be sure that the bit turns freely and does
not contact the base or trimmer shoe in any way.
1. Bit protrusion
2. Base
3. Nut
1
4. Scale
5. Adjusting screw
2
3
4
1. Wing bolt
2. Graduation
3. Wing nut
6
4. Trimmer shoe
5. Amount of
chamfering
6. Base
Switch action
1
006614
To start the tool, move the switch lever to the I (ON)
position. To stop the tool, move the switch lever to the O
(OFF) position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing trimmer bit
1
2
006629
CAUTION:
Do not tighten the collet nut without inserting a bit,
•
or the collet cone will break.
Use only the wrenches provided with the tool.
•
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches.
To remove the bit, follow the installation procedure in
reverse.
Installing trimmer shoe (after it has been
removed from the tool)
1
2
006630
5
1. Switch lever
1. Loosen
2. Tighten
3. Hold
3
1. Wing nut
2. Spring washer
3. Base
4. Trimmer shoe
3
5. Flat washer
6. Bolt
4
5
6