Outputting System Information To The Trap Buffer; Outputting System Information To The Log Buffer - HP 5500 EI Series Configuration Manual

Step
8. Specify a log host and
configure the related
output parameters.

Outputting system information to the trap buffer

The trap buffer only receives trap information, and discards log and debug information.
To output system information to the trap buffer:
Step
1. Enter system view.
2. Enable the information
center.
Name the channel with a
3.
specified channel number.
4. Configure an output
channel for the trap buffer
and specify the buffer size.
5. Configure an output rule
for the trap buffer.
6. Configure the timestamp
format.

Outputting system information to the log buffer

The log buffer only receives log information, and discards trap and debug information.
Command
info-center loghost [ vpn-instance
vpn-instance-name ]
{ host-ipv4-address | ipv6
host-ipv6-address } [ port
port-number ] [ dscp dscp-value ]
[ channel { channel-number |
channel-name } | facility
local-number ] *
Command
system-view
info-center enable
info-center channel channel-number
name channel-name
info-center trapbuffer [ channel
{ channel-number | channel-name } |
size buffersize ] *
info-center source { module-name |
default } channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
info-center timestamp { debugging |
log | trap } { boot | date | none }
46
Remarks
By default, no log host is specified.
If you use this command without
specifying an output channel, the
system uses channel 2 (loghost) by
default.
The value of the port-number
argument must be the same as the
value configured on the log host.
Otherwise, the log host cannot
receive system information.
Only the HP 5500 EI switches
support the vpn-instance keyword.
Remarks
N/A
Optional.
Enabled by default.
Optional.
See Table 2 for default channel
names.
Optional.
By default, system information is
output to the trap buffer through
channel 3 (known as trapbuffer)
and the default buffer size is 256.
Optional.
See "Default output rules of system
information."
Optional.
The timestamp format for system
information is date by default.