port that directly connects the switch to the management switch and its cascade ports are in the
management VLAN.
Management VLAN autonegotiation enables a cluster management switch to add ports directly
connected to it and cascades ports between cluster candidate switches to a management VLAN.
Enabling management VLAN autonegotiation can cause the following changes to ports connecting
member switches:
Access ports change to hybrid ports. These hybrid ports permit only the management VLAN to pass
•
through and are tagged members in the management VLAN.
Trunk and hybrid ports are assigned to the management VLAN, without any link type or removal of
•
VLANs that have added on the ports. Hybrid ports are added to the management VLAN as a
tagged member.
Before enabling the function, make sure you fully understand its impact on your network.
To enable management VLAN autonegotiation on the management switch:
Step
1.
Enter system view.
2.
Enter cluster view.
3.
Enable management VLAN
autonegotiation.
Configuring communication between the management switch
and the member switches within a cluster
In a cluster, the management switch and its member switches communicate by sending handshake
packets to maintain a connection. You can configure the interval for sending handshake packets and the
holdtime of a switch on the management switch. This configuration applies to all member switches within
the cluster. For a member switch in Connect state:
If the management switch does not receive handshake packets from a member switch within the
•
holdtime, it changes the state of the member switch to Disconnect. When the communication is
recovered, the member switch needs to be re-added to the cluster (this process is automatically
performed).
If the management switch receives handshake packets from the member switch within the holdtime,
•
the state of the member switch remains Active and the holdtime is restarted.
To configure communication between the management switch and the member switches within a cluster:
Step
1.
Enter system view.
2.
Enter cluster view.
Command
system-view
cluster
management-vlan synchronization
enable
Command
system-view
cluster
186
Remarks
N/A
N/A
By default, this function is
disabled.
Remarks
N/A
N/A