Configuring The Nqa Server; Enabling The Nqa Client; Creating An Nqa Test Group - HP 5500 EI Series Configuration Manual

Configuring the NQA server

To perform TCP, UDP echo, UDP jitter, or voice tests, configure the NQA server on the peer device. The
NQA server responds to the probe packets sent from the NQA client by listening to the specified
destination address and port number.
To configure the NQA server:
Step
1. Enter system view.
2. Enable the NQA server.
3. Configure the listening
service.
4. Configure the ToS value in
the packets sent by the TCP
or UDP listening service.

Enabling the NQA client

Configurations on the NQA client take effect only when the NQA client is enabled.
To enable the NQA client:
Step
1. Enter system view.
2. Enable the NQA client.

Creating an NQA test group

Create an NQA test group before you configure NQA tests.
To create an NQA test group:
Step
1. Enter system view.
Command
system-view
nqa server enable
nqa server { tcp-connect |
udp-echo } ip-address
port-number
nqa server { tcp-connect |
udp-echo } tos tos
Command
system-view
nqa agent enable
Command
system-view
117
Remarks
N/A
Disabled by default.
The destination IP address and port
number must be the same as those
configured on the NQA client. A
listening service must be unique on the
NQA server.
Optional.
By default, the ToS value is 0.
Remarks
N/A
Optional.
Enabled by default.
Remarks
N/A