Makita 4112H Instruction Manual page 8

ASSEMBLY
2
1. Shaft lock
2. Socket wrench
3
5
4
1. Flange
2. Ring
3. Wheel
4. Flange
5. Hex bolt
2
1
3
1. Dust nozzle
2. Elbow joint
3. Hose
8
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the wheel
004016
To remove the wheel, depress the shaft lock to hold the shaft
stationary, then loosen the hex bolt clockwise with the socket
wrench.
To install a wheel, place flange with its partly elevated side
facing the tool, and then place ring before installing a wheel
1
onto the spindle (shaft) and another flange with partly ele-
vated side facing outward.
Be sure to fully tighten the hex bolt counterclockwise after
mounting the new wheel, or operation will be dangerous.
004378
CAUTION:
• Use only the Makita wrench to install or remove the
wheel.
1
2
Connecting to vacuum cleaner
004379
When you wish to perform cleaner operation, connect a vac-
uum cleaner to your tool. Connect a hose of vacuum cleaner
to the dust nozzle via an elbow joint (accessory).