REMOVING THE FRONT WHEEL
EASB111122
1. Use a suitable stand to raise the front wheel
off the ground.
EWA
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Front wheel
CHECKING THE FRONT WHEEL
EASB111123
1. Check:
• Front wheel axle
Roll the front wheel axle on a flat surface.
Bends Replace.
EWA
WARNING
Do not attempt to straighten a bent wheel
axle.
2. Check:
• Tire(s)
• Front wheel
Damage/wear Replace.
Refer to "CHECKING THE TIRES" on page
3-34 and "CHECKING THE WHEELS" on
page 3-34.
3. Check:
• Spokes
Bend/damage Replace.
Loose Tighten.
Tap the spokes with a screwdriver.
TIP
A tight spoke will emit a clear, ringing tone; a
loose spoke will sound flat.
4. Tighten:
• Spokes
Refer to "CHECKING AND TIGHTENING
THE SPOKES" on page 3-34.
Spokes
2.5 Nm (0.25 m·kgf, 1.8 ft·lbf)
TIP
After tightening the spokes, measure the wheel
runout.
5. Measure:
• Wheel radial runout "a"
• Wheel lateral runout "b"
Out of specification Repair/replace.
Radial wheel runout limit
2.0 mm (0.08 in)
Lateral wheel runout limit
2.0 mm (0.08 in)
6. Check:
• Collars
Damage/wear Replace.
7. Check:
• Bearing
Front wheel turns roughly or is loose Re-
place the wheel bearings.
• Oil seals
Damage/wear Replace.
4-4
FRONT WHEEL
b
a