Page 1
Quick Install Guide Fixed Dome Network Camera This document will guide you through the basic installation process for your new D-Link Network Camera. DCS-6112/DCS-6113 Documentation also available on CD and via the D-Link Website...
DCS-6112/DCS-6113 Quick Install Guide This Quick Install Guide provides basic instructions for installing the DCS-6112/DCS-6113 Network Camera on your network. For additional information about how to use the camera, please see the User Manual which is available on the CD included in this package or from the D-Link support website.
2. Hardware Overview Dome Cover Camera Housing D-Link DCS-6112/DCS-6113 Quick Install Guide...
Page 4
4: Audio input 5: GND 6: Digital input 7: Digital output 8: 12V DC DC input / Video Output 1: Ground of Video out 2: Video output 3: Ground of DC input 4: DC 12V input D-Link DCS-6112/DCS-6113 Quick Install Guide...
5. The camera can be mounted with the cable routed through the ceiling, wall or from the side. 6. Insert the provided screws through the holes. Use a screwdriver to tighten the screws and secure the camera. D-Link DCS-6112/DCS-6113 Quick Install Guide...
Page 6
Connection with a PoE Switch If using a PoE switch, connect the network camera to the switch with an Ethernet cable, which will provide both power and data transmission over a single cable. D-Link DCS-6112/DCS-6113 Quick Install Guide...
Insert the DCS-6112/DCS-6113 CD into your computer's CD-ROM drive to begin the installation. If the autorun function on your computer is disabled, or if the D-Link Launcher fails to start automatically, click Start > Run. Type D:\autorun.exe, where D: represents the drive letter of your CD-ROM drive.
Page 8
Click on the D-Link Setup Wizard SE icon that was created in your Windows Start menu. Start > Programs > D-Link > Setup Wizard SE The Setup Wizard will display the MAC Address and Current IP Address of your camera(s). If you have a DHCP server on your network, a valid IP Address will be displayed.
Page 9
Viewing Live Video Using a Web Browser Click on the D-Link Setup Wizard SE icon that was created in your Windows Start menu. Start > Programs >D-Link > Setup Wizard SE Select your DCS-6112 or DCS-6113 and click Link to access the web configuration.
3. Use a small Phillips screwdriver to loosen the two screws behind the lens collar. Rotate the lens to adjust the network camera’s image until the desired orientation is achieved. Tighten the screws once adjustment is completed. Pan 350° Loosen Tighten Rotate Tilt 85° 350° D-Link DCS-6112/DCS-6113 Quick Install Guide...
3. Attach the dome cover to the camera as shown below. The dome cover cannot be attached if the angle is not correct. 4. Finally, make sure all parts of the camera are installed securely. Plate A D-Link DCS-6112/DCS-6113 Quick Install Guide...