Transporting - Honda BE-LS22TL6505GO Operation Manual

NEVER
1. Use when fluid is below 20° F or above 150° F.
2. Use a solid engine / pump coupling.
3. Operate through relief valve for more than 5 seconds.
4. Attempt to adjust the unloading or relief valve settings.
5. Operate with air in hydraulic system.
6. Use teflon tape on hydraulic fittings.
7. Attempt to cut wood across the grain.
8. Attempt to remove partially split wood from the wedge with your hands.
Fully retract the wedge to dislodge wood with log dislodger.

TRANSPORTING

1. Lower the beam to its horizontal position. Make certain the beam is
locked securely with the horizontal beam lock.
2. Change the jack stand to transporting position.
1) Remove the spring clip and clevis pin from the jack stand.
2) Support the tongue and pivot the jack stand up against the tongue.
3) Secure with the spring clip and clevis pin previously removed.
3. Attach the coupler hitch to a class I or higher 2" ball on the towing
vehicle latch securely.
1) If the coupler hitch does not fit on the ball, turn the adjustment nut
one turn counter-clockwise.
2) If the coupler hitch is too loose on the ball, turn the adjustment nut
one turn clockwise. Then recheck and adjust accordingly.
4. Connect the safety chains to the towing vehicle.
• Do not tow faster than 45mph and check the local, state and federal
requirements before towing on any public road.
• Use caution when backing up, using a spotter outside the vehicle is
recommended.
36
OPERATION
WARNING
NOTICE