Set-Up; Gas And Oil Fill-Up; Tire Pressure; Preparing The Log Splitter - Honda BE-LS22TL6505GO Operation Manual

Set-Up

GAS AND OIL FILL-UP

Service the engine with gasoline and oil as instructed in the engine
manual packed with your log splitter. Read the instructions carefully.
• Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
• Your log splitter is shipped with motor oil in the engine. You MUST
check the oil level before operating. Be careful not to overfill.
Gasoline can be added to the engine when the log splitter is in either
the horizontal or vertical position. However, it may be easier when the
splitter is in the vertical position.

TIRE PRESSURE

The max recommended operating pressure is 30 psi. Under any
circumstances do not exceed the manufacturer's recommended psi.
Maintain equal pressure on all tires.
• Excessive pressure when seating beads may cause tire/rim assembly
to burst with force sufficient to cause serious injury.

PREPARING THE LOG SPLITTER

1. Lubricate the beam area (where the splitting wedge will slide) with
engine oil. Do not use grease.
2. Fill hydraulic oil before your initial use.
28
SET-UP
WARNING
NOTICE
WARNING