Honda BE-LS22TL6505GO Operation Manual page 21

REF # DESCRIPTION
6 Tongue & Jack stand assembly
7 Hardware Kit #3 (not shown) Including:
7-1 Horizontal beam lock
7-2 Hex head bolt / M10 x 80
7-3 Flat washer / M10
7-4 Lock nut / M10
STEP 4: Assemble the pump assembly to the engine.
1. Loosen the set screw on the coupler at the engine side.
2. Place the engine shaft key into the slot on the engine shaft.
3. Insert the engine shaft into the center hole of coupler, pivoting the
pump assembly to ensure the engine shaft key to fit in the slot of the
coupler center hole. Then tighten the set screw just loosened.
4. Rotate the engine shaft to align the fixing holes on both pump mount
and engine, and ensure the open side of the pump mount facing
down as shown in the illustration below, then screw on the hardware
and tighten.
REF # DESCRIPTION
8 Engine assembly (in engine box, not shown) Including:
8-1 Engine
8-2 Engine shaft key
9 Hardware Kit #4 (not shown) Including:
9-1 Two stage pump assembly
9-2 Hex head bolt / 5/16-24
9-3 Spring washer / 5/16
9-4 Flat washer / 5/16
ASSEMBLY
QTY
1
1
1
4
8
4
QTY
1
1
1
1
1
4
4
4
21