STEP 5: Attach the engine assembly to the engine mount plate on the
reservoir assembly.
REF #
DESCRIPTION
10
Hardware kit #5 (not shown) Including:
10-1
Hex head bolt / M8 x 40
10-2
Flat washer / M8
10-3
Lock nut / M8
STEP 6: Assemble the beam.
1. Stand the beam up on end. Two or more people may be needed for
this step to ensure safety. Make sure that the beam is stable and on
a level surface.
2. Remove the clevis pin and spring pin from the tank brackets. Roll
the tongue/ tank assembly into position between the two tabs on
the beam. Slide the clevis pin through the aligned holes and lock in
place with the spring clip.
22
ASSEMBLY
QTY
1
4
8
4