Standard Security Modes - Honeywell LYNX Touch 7000 Owner's Manual

Standard Security Modes

The following Security Modes are pre-programmed:
1– AWAY ALL ON
2– AWAY PARTIAL
3– HOME
4– HOME SLEEP
5– ON WATCH
6– SYSTEM TEST
74-2760—1
• All perimeter and interior security protection points
are on.
• Exit and entry delay.
M6936
• Perimeter protection is on.
• Only predetermined interior protection is on.
Example: This may be used when running an
M6937
• Exit and entry delay.
• Perimeter protection is on.
• Only predetermined interior protection is on.
• No exit delay.
M6938
• There is an entry delay if someone opens an
entry door.
Example: Use this mode when you are home,
• Perimeter protection is on.
• Only predetermined interior protection is on.
• No exit delay.
M6939
• No entry delay. system instantly alarms when a
security point is tripped.
Example: Use this mode when nobody will be
• All points you have designated as ON WATCH
sound a short audible when tripped, and display the
tripped point on the keypad for 20 seconds.
M6940
• All perimeter and interior protection is ON WATCH,
sounds a short audible when tripped, and displays
the tripped point on the keypad for 20 seconds.
M6941 • Allows customer to test each point of protection.
errand and pets are roaming free in
the house.
you want your exterior protection on,
and you may have people entering
your home.
entering or leaving your home and
everyone is asleep. If someone were to
walk through a door, the system will
instantly alarm.
16