Maintenance - Makita UT2204 Instruction Manual

MAINTENANCE

1
1. Filter
2. Cover
3. Screwdriver
1. Limit mark
1. Screwdriver
2. Brush holder cap
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
• Mixing blades
8
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing filter
007098
Replace the filter regularly as the cooling efficiency of the tool is reduced due
2
to built-up dust or particles in the filter.
Insert the slotted bit screwdriver and the like between the tool and the cover as
shown in the figure. Lift it up just like using a shovel and remove the cover.
Replace the filter in the cover with a new one.
Reinstall the cover on the tool.
3
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
007099
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
1
nance or adjustment should be performed by Makita Authorized Service Cent-
2
ers, always using Makita replacement parts.
• Shaft