Functional Description - Makita UT2204 Instruction Manual

FUNCTIONAL
DESCRIPTION
1. Lock button
2. Switch trigger
1. Indicator lamp
ASSEMBLY
1
3
2
1. Hex nut
2. Shaft
3. Shaft holder
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Switch action
007096
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
1
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release the switch trigger to
2
stop.
For continuous operation, pull the switch trigger and then push in the lock but-
ton.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
Indicator lamp
007097
The green power-ON indicator lamp lights up when the tool is plugged to the
mains. If the indicator lamp is lit but the tool does not start even if the tool is
switched ON, the carbon brushes may be worn out, or the motor or the switch
may be defective. If the indicator lamp does not light up, the mains cord or the
1
indicator lamp may be defective. When the mains cord is defective, the tool
neither starts nor lights the indicator lamp. When the indicator lamp is defec-
tive, the tool starts without the indicator lamp lighting up.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing shaft
007092
Tighten the shaft with hex. Nut into the shaft holder as far as the hex nut
comes into contact with the holder..
5