Table of Contents
Advertisement
Symptom [DVD]
Audio soundtrack and/or subtitle
language is not the one selected at the
initial settings.
The menu is displayed in French
(example).
Lightening and darkening of the picture.
No subtitles.
Alternative audio soundtrack (or subtitle)
languages fail to be selected.
Angle cannot be changed.
The password for rating level has been
forgotten.
Reset all the settings to Factory preset.
Symptom [Video CD]
No menu play.
Self-diagnosis display function
When an error or trouble is detected during operation, a service number appears in the display window.
When a service number has appeared, check out the details given below.
Service number
U11
H Å Å
Product service
Do not attempt to remove the cover(s) or repair the unit
yourself. Refer servicing to qualified personnel only.
The servicer will require all components to service your
system. Therefore, should service ever be necessary,
be sure to bring the entire system.
Downloaded From Disc-Player.com Yamaha Manuals
If the audio soundtrack and/or subtitle language does not exist on the disc, the
language selected at the initial settings will not be seen/heard.
The setup "Menus" of "Disc Languages" is set to French: select English.
Some discs will be copy protected at the direction of copyright owners. During
playback of those discs, picture may not be normally played back when video
signals containing a copy protected signal are played back through a VCR. It is
recommended to connect the DVD/Video CD/CD player directly to an AV amplifier
or to a TV set, not through a VCR.
ÁSubtitles appear only with discs which contain them.
ÁSubtitles are cleared from the TV monitor. Perform the steps on page 54 to display
the subtitles.
ÁAn alternative language is not selected with discs which do not contain more than
one language.
ÁIn the case of some discs, the alternative language cannot be selected by
operating the AUDIO or SUBTITLE button. Try selecting it from the DVD menu if
one is available.
This function is dependent on software availability. Even if a disc has a number of
angles recorded, these angles may be recorded for specific scenes only (when the
ANGLE indicator lights up on the unit's display.)
While the unit is in the stop mode, hold the unit's 0 SKIP button and the STILL/
PAUSE button down simultaneously and then hold the POWER button down for
longer than 3 seconds (until "Initialized" disappears from the TV monitor). The lock
will be released and all initial settings will return to the default values.
This function works only for Video CDs with playback control.
Player status
Disc is dirty.
Trouble is likely to have occurred. The
number following "H" differs depending
on the status of the player.
Remedy
Remedy
Remedy
Wipe the disc clean.
Set the POWER button to OFF and then back to ON.
Alternatively, switch the power to the standby mode,
disconnect the AC power plug, and then re-connect it.
If the service number fails to be cleared even when the
remedial action is taken, ask for the service engineer to repair
the player.
87
Advertisement
Table of Contents
