Honeywell V2.X Installation Manual page 7

Once within the UPnP menu, perform the following.
1. Enable UPnP by clicking in the box to the right of "Enable UPnP".
2. Set Mapping Type to "Manual"
3. Enable UPnP Reporting Authorized use by clicking in the box to the right of "UPnP Reporting Authorized use"
a. A password is required to enable this required function
b. Click in the box where the password will be entered
c. Using the virtual keyboard, enter "iview123" (no quotes).
d. Select "Enter", then "OK".
4. Set the Server port to 8000
5. Set the HTTP Port to 8001
6. Set the RTSP Port to 8002
7. Click "Apply" at the bottom right of the screen.
8. UPnP Reporting is now enable and the DVR will begin reporting its IP address and ports to the I-View Now
Server. The initial reporting could take up to 5 minutes and can only be tested after completing the SMTP
configuration section.
Honeywell HRGX Series Installation Guide rev 2.X I-View Now, LLC. All Rights Reserved. © 2014 Page 7