24. Do not use water or grinding lubricant.
25. Ensure that ventilation openings are kept clear
when working in dusty conditions. If it should
become
necessary
disconnect the tool from the mains supply
( use non metallic objects ) and avoid
damaging internal parts.
26. When use cut-off wheel, always work with the
dust collecting wheel guard required by
domestic regulation.
27. Cutting discs must not be subjected to any
lateral pressure.
SAVE THESE INSTRUCTIONS.
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Shaft lock
1
008446
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
1
008438
to
clear
dust,
first
1. Shaft lock
1. Switch lever
CAUTION:
Before plugging in the tool, always check to see
•
that the tool is switched off.
To start the tool, move the switch lever to the (ON)
position. To stop the tool, move the switch lever to the
(OFF) position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing depressed center
wheel
008436
Screw the inner flange onto the spindle. Fit the wheel on
the inner flange and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
2
008437
To remove the wheel, follow the installation procedure in
reverse.
WARNING:
Only actuate the shaft lock when the spindle is not
moving.
4
1. Lock nut
1
2. Depressed
center wheel
2
3. Inner flange
3
1. Lock nut wrench
2. Shaft lock
1