NETGEAR ProSafe FVS124G Reference Manual page 63

Reference Manual for the ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN Ports
• Test Period—DNS query is sent periodically after every test period. The minimum test
period is 30 seconds.
• Maximum Failures—The WAN interface is considered down after the configured number
of DNS queries have failed to elicit a DNS reply from the configured DNS server. The
minimum number of failed DNS queries is four.
The minimum time for a WAN interface to be classified as having failed is two minutes (i.e.,
30 second minimum test period times a minimum of four tests). All traffic then stops on that
WAN port. Traffic that is not bound by protocol to the failed WAN port is then sent to the
working WAN port. If the total traffic on the working WAN port exceeds its bandwidth, then
congestion occurs.
Once a WAN interface fails, an alert will be generated (see
Event Logs and Alerts" on page
before it can carry traffic again by reapplying the WAN Mode menu shown in
Click Add in the appropriate WAN interface section of the WAN Mode Load Balancing screen
2.
to invoke the WAN Mode Protocol Bonding screen (if protocol binding is needed). Fill out the
screen using the following parameter definitions:
• Service—Select the desired Services or applications to be covered by this rule. If the
desired service or application does not appear in the list, you must define it using the
Services menu (see
• Source Network—These settings determine which computers on your network are
affected by this rule. Select the desired options:
– Any—All PCs and devices on your LAN.
– Single address—Enter the required address and the rule will be applied to that
particular PC.
– Address range —If this option is selected, you must enter the start and finish fields.
– Groups—Select the Group you wish this rule to apply to. You can use the Network
Database screen to assign PCs to Groups.
• Destination Network—These settings determine which Internet locations are covered by
the rule, based on their IP address. Select the desired option:
– Any—All Internet IP address are covered by this rule.
– Single address—Enter the required address in the start fields.
– Address range—If this option is selected, you must enter the start and finish fields.
Connecting the FVS124G to the Internet
6-30). You must then get the failed WAN interface restored
"Services-Based Rules" on page
202-10085-01, March 2005
"Getting E-Mail Notifications of
Figure
6-4).
4-10.
4-19