DG834G v5 to FVL328
This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
DG834G v5 to a FVL328. This case study follows the VPN Consortium interoperability profile
guidelines (found at http://www.vpnc.org/InteropProfiles/Interop-01.html).
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify that the firmware is up to date, and that you have all the addresses that will be
necessary, and all of the parameters that need to be set on both sides. Check that there are no
firewall restrictions.
Table B-1. Profile Summary
VPN Consortium Scenario:
Type of VPN
Security scheme:
IP Addressing:
NETGEAR-Gateway A
NETGEAR-Gateway B
NETGEAR VPN Configuration
NETGEAR VPN Configuration
Scenario 1
LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
IKE with Preshared Secret/Key (not certificate-based)
Static IP address
Static IP address
v1.0, May 2008
Appendix B
B-1