NETGEAR DG834G 54 Mbps Wireless ADSL Firewall DG834G DG834G User Manual page 130

Wireless adsl2+ modem router
Hide thumbs Also See for DG834G 54 Mbps Wireless ADSL Firewall DG834G DG834G:
Table of Contents

Advertisement

Wireless ADSL2+ Modem Router DG834G User Manual
Table 6-5. VPN-Auto Policy Screen Settings (continued)
Fields and Settings
Parameters
Encryption
Algorithm
Authentication
Algorithm
Pre-shared key
SA Life Time
Enable IPSec
PFS (Perfect
Forward
Secrecy)
6-36
Description
The encryption algorithm used for both IKE and IPSec. This setting
must match the setting used on the remote VPN Gateway. DES and
3DES are supported.
• DES. The Data Encryption Standard (DES) processes input data that
is 64 bits wide, encrypting these values using a 56-bit key. Faster but
less secure than 3DES.
• 3DES. (Triple DES) achieves a higher level of security by encrypting
the data three times using DES with three different, unrelated keys.
The authentication algorithm used for both IKE and IPSec. This setting
must match the setting used on the remote VPN Gateway. Auto, MD5,
and SHA-1 are supported. Auto negotiates with the remote VPN
endpoint and is not available in responder-only mode.
• MD5. 128 bits, faster but less secure.
• SHA-1. (default)160 bits, slower but more secure. This is the default.
The key must be entered both here and on the remote VPN Gateway.
This determines the time interval before the SA (Security Association)
expires. (It will automatically be re-established as required.) While
using a short time period (or data amount) increases security, it also
degrades performance. It is common to use periods over an hour (3600
seconds) for the SA Life Time. This setting applies to both IKE and
IPSec SAs.
• If this check box is selected, security is enhanced by ensuring that the
key is changed at regular intervals. Also, even if one key is broken,
subsequent keys are no easier to break. (Each key has no
relationship to the previous key.)
• This setting applies to both IKE and IPSec SAs. When configuring the
remote endpoint to match this setting, you might have to specify the
key group used. For this device, the key group is the same as the DH
Group setting in the IKE section.
v1.0, May 2008
Virtual Private Networking

Advertisement

Table of Contents
loading

Table of Contents