NETGEAR DG834G 54 Mbps Wireless ADSL Firewall DG834G DG834G User Manual page 81

2. Change the settings. For more information, see
DHCP Server" on page 5-6
3. Click Apply to save the changes.
The LAN TCP/IP Setup parameters are explained in the following table.
Table 5-2. LAN IP Setup
Settings
LAN TCP/IP IP Address
Setup
IP Subnet Mask
RIP Direction
RIP Version
DHCP Server Use Router as a DHCP
For more Server
information, see
"Using the
Modem Router
Starting IP Address
as a DHCP
Server" on
Ending IP Address
page 5-6.
Advanced Configuration
Wireless ADSL2+ Modem Router DG834G User Manual
Table
or "Defining Reserved IP Addresses" on page
Description
The LAN IP address of the modem router.
The LAN subnet mask of the modem router. Combined with
the IP address, the IP Subnet Mask allows a device to know
which other addresses are local to it, and which must be
reached through a gateway or modem router.
RIP (Router Information Protocol) allows a modem router to
exchange routing information with other routers. This
setting controls how the modem router sends and receives
RIP packets. Both is the default.
• Both or Out Only. The modem router broadcasts its
routing table periodically.
• Both or In Only. The modem router incorporates the RIP
information that it receives.
• None. The modem router will not send any RIP packets
and will ignore any RIP packets received.
This controls the format and the broadcasting method of the
RIP packets that the modem router sends. It recognizes
both formats when receiving. By default, this is RIP-1.
• RIP-1 is universally supported. It is adequate for most
networks, unless you have an unusual network setup.
• RIP-2 carries more information. Both RIP-2B and RIP-2M
send the routing data in RIP-2 format. RIP-2B uses
subnet broadcasting. RIP-2M uses multicasting.
This check box is usually selected so that the modem router
functions as a Dynamic Host Configuration Protocol
(DHCP) server. See
Server" on page
Specify the start of the range for the pool of IP addresses in
the same subnet as the modem router.
Specify the end of the range for the pool of IP addresses in
the same subnet as the modem router.
v1.0, May 2008
5-2, "Using the Modem Router as a
5-7.
"Using the Modem Router as a DHCP
5-6.
5-5