Technical Specifications; Electrical Wiring; Compliance - Buffalo CD400 Instruction Manual

Telephone Helpline: 0845 146 2887 (United Kingdom)
Fault
Minced meat does not exit the
appliance evenly

Technical Specifications

Model Voltage
CD400 230V 50Hz

Electrical Wiring

This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible
for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with
regulatory standards and specifications set by international, independent, and federal
authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the
Probable Cause
The barrel cap is on too tight
The cutting plate is blocked
The cutting blade is blunt
Power Current
800W 3.6A
right to change specifications without notice.
Loosen the cap
Remove and clean the plate
Replace the cutting blade
Capacity Output
3.5kg 250kg/hour
Action
Dimensions
Weight
h x w x d mm
410 x 328 x 517 24.5kg
UK
4