Optimizing An Rgb Image Automatically; Turning Up Or Down Volume - NEC HT410 User Manual

3. PROJECTING AN IMAGE (BASIC OPERATION)

Optimizing an RGB Image Automatically

Adjusting the Image Using Auto Adjust
Optimizing an RGB image automatically
Press the AUTO ADJ. button to optimize an RGB image automatically.
Cabinet controls
LAMP
STATUS
POWER
SOURCE SELECT
ON/STAND BY
AUTO
ADJ.
Press the AUTO ADJ. button to fine-tune the computer image or to remove any vertical banding that might
appear and to reduce video noise, dot interference or cross talk (this is evident when part of your image appears
to be shimmering). This function adjusts the clock frequencies that eliminate the horizontal banding in the image.
This function also adjusts the clock phase to reduce video noise, dot interference or cross talk. (This is evident
when part of your image appears to be shimmering.)
This adjustment may be necessary when you connect your computer for the first time.
NOTE:
• Some signals may not be displayed correctly or take time.
• The Auto Adjust function does not work for component and video signals.
• If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Clock and Phase manually. See page E-37.

Turning Up or Down Volume

Sound level from the speaker can be adjusted.
Cabinet controls
decrease volume
LAMP
STATUS
POWER
SOURCE
ON/STAND BY
AUTO
ADJ.
NOTE: When no menus appear, the SELECT
Remote control
OFF
VIDEO
S-VIDEO
increase volume
SELECT
and buttons on the projector cabinet work as a volume control.
[Poor picture]
POWER ON
COMPONENT COMPUTER
C-VIDEO COMP.
AUTO ADJ.
AUTO
[Normal picture]
increase volume
decrease volume
E-27
Remote control
PIC-MUTE OFF TIMER
MUTE FREEZE TIMER
HELP
VOLUME KEY STONE
LIGHT