Terminal Panel Features - NEC HT410 User Manual

1. INTRODUCTION

Terminal Panel Features

7
PC CONTROL
1. COMPUTER IN / Component Input Connector (Mini D-Sub 15 Pin)
Connect your computer or other analog RGB equipment such as IBM compatible or Macintosh computers.
Use the supplied RGB/VGA cable to connect to your computer. This also serves as a component input con-
nector that allows you to connect a component video output of component equipment such as a DVD player
(optional adapter ADP-CV1 required).
2. AUDIO IN mini jack (Stereo Mini)
This is where you connect the audio output from your computer or DVD player when connected to the COM-
PUTER IN or COMPONENT IN.
3. COMPONENT IN (Y, Cb/Pb, Cr/Pr) connectors (RCA)
Connect component video outputs (Y/Cb/Cr, Y/Pb/Pr) here from external equipment such as a DVD player.
4. S-VIDEO IN connector (Mini DIN 4 Pin)
Here is where you connect the S-Video output from an external source like a VCR.
NOTE: S-Video provides more vivid color and higher resolution than the traditional composite video format.
5. VIDEO IN connector (RCA)
Connect a VCR, DVD player, laser disc player, or document camera here to project video.
6. AUDIO IN jacks L & R (RCA)
These are your left and right channel audio inputs for stereo sound from a Video or S-Video source.
7. PC CONTROL Port (Mini DIN 8 Pin)
Use this port to connect a PC or control system. This enables you to control the projector using serial commu-
nication protocol. If you are writing your own program, typical PC control codes are on page E-57.
1 3
Y Cb/Pb
COMPUTER IN
Cr/Pr
AUDIO IN COMPONENT IN
2
E-5
4 6
S-VIDEO IN
L
VIDEO IN R AUDIO IN
5