Advertisement
(3)ASSEMBLY OF SAFETY COVER
1) Insert Spiral spring 26 into the oval hole in Safety cover , making spring's tip meet the hole.
2) Making Center washer meet four bosses in Safety cover , and attach it. (See Fig.1)
3) By putting the tip of Spiral spring 26 into Center cover hole, attach Center cover as shown in Fig. 2.
4) Attach Center plate, making it meet four bosses in Safety cover, and tighten it with Pan head screw M5.
Oval hole in Safety cover
(4)ASSEMBLY OF SQUARE ROD COMPLETE AND RING 26
1) Passing Ring 26 through Slide pipe 25-235 as in the figure, attach Arm-holder complete to Turn base complete.
2) Slide Arm-holder complete until the groove on the top of Slide pipe 25-235 comes to the center of Turn base,
and then attach Square rod complete.
3) Attach Thumb nut 6x33 and H.socket bolt to meet the hole of Turn base and that of Ring26.
Thumb nut 6x33
(5)ASSEMBLY/DISASSEMBLY OF TURN BASE AND BASE
1) When detaching/ attaching Turn base from/to Base, push Lock lever first.
2) Adjust the torque of Hex. lock nut M8 in the center of Turn base so that Turn base may turn smoothly without trembling.
Hex. lock nut M8
Spiral spring 26
Flat washer 5
Pan head screw M5
Fig. 1
Arm-holder complete
H.socket bolt
Ring 26
Slide pipe 25-235
Turn base
Lock lever
Spiral spring 26
Center washer
Center plate
Center cover
Safety cover
Turn base complete
Base
Center cover hole
Square rod complete
Rubber pin
Fig. 2
Advertisement
