Switch Action; Electric Brake - Makita LS0714 Instruction Manual

depressed, tilt the saw blade to the right.
CAUTION:
When tilting the saw blade, be sure to raise the
•
handle fully.
After changing the bevel angle, always secure the
•
arm by tightening the lever clockwise.
When changing bevel angles, be sure to position
•
the kerf boards appropriately as explained in the
"Positioning kerf boards" section.
Adjusting the lever position
1
2
003932
The lever can be repositioned at every angle 30° when
the lever does not provide full tightening.
Loosen and remove the screw that secures the lever at
the rear of the tool. Remove the lever and install it again
so that it is slightly above the level. Secure the lever with
the screw firmly.

Switch action

CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
When not using the tool, remove the lock-off button
•
and store it in a secure place. This prevents
unauthorized operation.
Do not pull the switch trigger hard without pressing
•
in the lock-off button. This can cause switch
breakage.
1
2
002253
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
1. Lever
2. Screw
1. Lock-off button
2. Switch trigger
3
3. Handle
WARNING:
NEVER use tool without a fully operative switch
•
trigger. Any tool with an inoperative switch is
HIGHLY DANGEROUS and must be repaired
before further usage.
For your safety, this tool is equipped with a lock-off
•
button which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the
lock-off button. Return tool to a Makita service
center for proper repairs BEFORE further usage.
NEVER tape down or defeat purpose and function
•
of lock-off button.

Electric brake

This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop blade after switch
trigger release, have tool serviced at a Makita service
center.
Lighting up the lamps
The blade brake system is not a substitute for blade guard.
NEVER USE TOOL WITHOUT A FUNCTIONING BLADE
GUARD. SERIOUS PERSONAL INJURY CAN RESULT.
For model LS0714FL only
1
005518
CAUTION:
This is not a rainproof light. Do not wash the light in
•
water or use it in a rain or a wet area. Such a
conduct can cause an electric shock and fume.
Do not touch the lens of the light, as it is very hot
•
while it is lighted or shortly after it is turned off. This
may cause a burn to a human body.
Do not apply impact to the light, which may cause
•
damage or shorted service time to it.
Do not keep casting the beam of the light to your
•
eyes. This can cause your eyes to be hurt.
Do not cover the light with clothes, carton,
•
cardboard or similar objects while it is lighted,
which can cause a fire or an ignition.
Push the upper position of the switch for turning on the
light and the lower position for off.
Move the light to shift an area of lighting.
8
1. Light
2. Light switch
2