After Use; Optional Accessories - Makita LS1016 Instruction Manual

brushes should be replaced at the same time. Use only
identical carbon brushes. (Fig. 69)
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps. (Fig. 70)
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 minutes.
Then check the tool while running and electric brake
operation when releasing the switch trigger. If the electric
brake is not working correctly, have the tool repaired by a
Makita service center.

After use

• After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding
portions with machine oil to prevent rust.
• When storing the tool, pull the carriage toward you fully
so that the slide pole is thoroughly inserted into the turn
base.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.

OPTIONAL ACCESSORIES

WARNING:
• These Makita accessories or attachments are
recommended for use with your Makita tool
spcified in this manual. The use of any other
accessories or attachments may result in serious
personal injury.
• Only use the Makita accessory or attachment for its
stated purpose. Misuse of an accessory or attachment
may result in serious personal injury.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Steel & Carbide-tipped saw blades
For smooth and precise cutting in
Miter saw blades
various materials.
General purpose blade for fast and
Combination
smooth rip, crosscuts and miters.
For smoother cross grain cuts. Slices
Crosscutting
cleanly against the grain.
For sand-free cuts cleanly against the
Fine cross cuts
grain.
Non-ferrous
For miters in aluminum, copper, brass,
metals miter saw
tubing, and other non-ferrous metals.
blades
006526
• Vise assembly (Horizontal vise)
• Vertical vise
• Hex wrench 6
• Socket wrench 13
• Holder
• Dust bag
• Crown molding stopper set
• Triangular rule
• Dust box
• Hex wrench (for LS1016L)
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ from
country to country.
25