Advertisement
(8)
Mounting of chuck
Check that change ring is mounted on the specified position. (See page 5/6 (6).)
Mount the chuck following the procedures below.
1) Set the chuck on sleeve 10.
2) Mount hexagonal rod to the chuck and fix it with a vice.
3) Set drill mode to forward and slow.
4) Mount battery that is fully charged and hold the handle securely. *
5) Set trigger to full speed in 1 second taking care not to strike an impact.
* When the handle is held loose, it may turn recklessly in the case of locking.
W
iring diagram
Spring terminal
Switch
Orange
M2
M2
Black
Red marks
DC motor
Advertisement
