Mount The Camera - D-Link DCS-960L User Manual

Section 2: Installation
Refer to the steps below to assist you with mounting the camera. We suggest that you configure the camera before mounting.
1. Turn the base plate on the bottom of the camera counterclockwise
with a coin to remove it.
2. Place the base plate where you want to position the camera and
use a pencil to mark the holes. Make sure the holes are lined up
horizontally.
3. Depending on the material of the wall or ceiling, use proper tools
to drill two holes 25mm deep with a 6mm drill bit where you
marked. If the wall is made out of concrete, drill the holes first, then
insert the plastic anchors to support the screws.
4. Place the base plate over the holes that are in the wall. Make sure
to align the base plate holes with the holes in the wall. Use the
supplied screws to attach the base plate to the surface of the wall.
Do not overtighten screwheads as this may crack the mount.
D-Link DCS-960L User Manual

Mount the Camera

1
2
3
4
12