Table of Contents
Advertisement
(D
OVEN USE
Be sure oven control is set in the OFF position prior to
• Do not lock oven door during a bake or broil operatiol
supplyinggas to the appliance.
- If door is locked, beeps will sound and "door"will
Yourappliance features pilotless ignition.A glo bar will
flash in display when the BAKE or BROIL pad is
lightthe oven burner.With this type of ignition system, the
pressed.
oven will not operate during a powerfailure or if the oven
is disconnectedfrom the wall outlet. No attempt should
be made to operate oven during a power failure.
- If door is locked during a cooking operation,the
The size and appearance of a properly adjusted oven
operationwill be canceledand, if oven temperatur_
burner flame should be as shown:
is above 400°F,the internal locking mechanismwill
engage. The door can not be unlocked and opene(
untilthe oven has cooled.
• The oven burner cycles on and off to maintain the ov_
temperaturefor baking.The broil burner turns on for
!!_
broiling and cycles on and off to maintain the broil
Cone in center is smaller
temperature.
• If you press BAKE or BROILpad and do not set an
oven temperature or broil setting within 30 seconds, tl
_
programwill automatically cancel. The time of day wil
-_ _' -_
Cone approx. 1/2-inch
reappear in the display.
• To change oven temperature during
cooking,press • or • pad to select
The oven temperature is maintained by cycling the burner
newtemperature.
on and off. After the oven temperature has been set, there
will be abouta 45 second delay before the burner ignites.
This is normal and no gas escapes during this delay.
Duringthe clean cycle, and some extended oven cooking
The Oven Control Lock-Outfeature preventsthe oven
operations,you may hear a "popping" sound when the
from being turned on. This is especially helpfulwhen
burner cycles off. This is a normal operatingsound of the
cleaning the control panel.
burner.
To activate:
1. Press and hold STOP
I Cookl
TIME and CANCEL pads _
and
for 3 seconds.
The oven vent is locatedat the base of the backguard.
2. Repeat step 1 to deactivate this feature.
Whenthe oven is in use, this area may feel warm or hot to
the touch.To prevent baking problems,do not block the
Whenthis feature is activated, OFF will appear in the
vent opening in any way.Also, do not place plastics near
temperaturedisplay for 15 secondswhenever any pad i_,
the vent opening as heat from the vent could distortor
pressed.
melt the plastic.
l -_l . -l i-I OFF
IL . LI
NOTE: The current time of day will remain in the display
when this feature is activated.
Advertisement
Table of Contents
