Table of Contents
Advertisement
o
SERVICE INF()RMATI(IN
°
Applianceswhich require electrical power are
You can adjust the oven temperature if you feel the
equipped with a three-pronggrounding plugwhich
temperature is too hot or too cool.
mustbe pluggeddirectlyintoa properlygrounded
three-hole120 voltelectrical o utlet.
To adjust the oven temperature:
1. PressBAKE pad.
2. Press • pad until 550° is
]Bake] then
displayed.
l .
l
3. Press and hold BAKE pad
__
until 0° appearsin display.
__
4. Press and hold the •
:
or • pad to select the
Always disconnect power to appliance before servicing,
temperature change
you wish.
The three-prong grounding plug offersprotection against
• The oven temperature can be increased or
shockhazards. DO NOT CUT OR REMOVETHE THIRD
decreased by 5° to 35°.
GROUNDINGPRONG FROMTHE POWER CORD
• If the oven temperature was previouslyadjusted,
PLUG.
the change will be displayed.
If an ungrounded,two-hole or other type electrical outlet is
For example: If the oven temperaturewas reducedby ]
encountered,it is the personal responsibility of the
the d splay wi!l show -15%
I
appliance owner to have the outlet replacedwith a
,,
properlygroundedthree-hole electricaloutlet,
It is notnecessaryto readjustthe oventemperatureif there
is a power failure or interruption. Broilingand cleaning
temperatures cannot be adjusted.
The LOW setting should producea stableflame when
turning the knob from HI to LO.The flame should be 1/8
inch or lower and must be stable on all ports on LOW
If a fault code appears in the displayand continuous
setting,
beeps sound, press the CANCEL pad. Then, reprogram
To adjust: Operate burner on HI for about5 minutesto
the cooking operation. If the fault code reappearsin the
preheat burner cap. Turn knob backto LO; removeknob,
display, call an authorized servicer. Do not use the oven
and insert a small screwdriverinto the center of the valve
until the appliance has been serviced.
stem. Adjust flame size by turning adjustment screw in
NOTE: If the oven is heavily soiled, excessive smoke and
eitherdirection,
flaring may result in a fault code during a self-clean cycle.
If this occurs, pressthe CANCEL pad and allow the oven
to cool for an hour.
Flame must be of sufficientsize to be stable on all burner
ports. If flame adjustment is needed, adjust ONLY onthe
LO setting.Never adjust flame size on a higher setting.
NOTE: All gas adjustments shouldbe done by a qualified
servicer only.
Advertisement
Table of Contents
