Sweeper Mode Assembly; Vacuum Mode Assembly; Li-Ion Battery Packs And Chargers; Collection Bag - Black & Decker LSWV36 Instruction Manual

This product ca.n accept any of the batteries and
argers iis_ea in the cnar_ [_elow.
LI=ION Battery Packs and Chargers
iDescription Cat. #
Batteries: LI-ION LBX36
LBXR36
LBXR2036
Chargers: LI-ION LCS36
LCS436
NOTE: Ensure the sweeper[A
is switched off and the _ _ .J
battery is removed before / _ _,
attaching or removing | .....
the sweeper tubes. The |
tube assembly must be L '_ I
assembled to the housing
before use.
• TUBE ASSEMBLY: To attach the two
piece sweeper tubes to the sweeper, line
up the tube with the sweeper housing as
shown in figure D. Push the tube into
the sweeper housing until the lock lever
engages the lock hole in the tube.
• FAN COVER ASSEMBLY: To attach the
fan cover to the sweeper, line up the tabs
on the cover with the sweeper housing
slots as shown in figure D1. Push the cover into the sweeper
housing until the locking/release button is fully engaged.
(This comes pre-assembled from the factory).
COLLECTION BAG (FIGURE E)
• Remove sweeper tube if attached.
• Push the collection bag on to the
sweeper housing until the lock lever
engages the lock hole as shown in
figure E.
• Attach collection bag clip to the lower
rear of the unit as shown in figure El.
VACUUM TUBE ASSEMBLY
(FIGURES F, G, H, H1)
NOTE: Ensure the sweeper is switched
off and the battery is removed before
attaching or removing the vacuum tubes.
The vacuum tube and collection bag must
be assembled to the housing before use.
• Vacuum tubes must be assembled
together before use.
• Align the notches and the triangles on
upper and lower tubes. (figure F)
• Push the lower tube firmly into the
upper tube, until the triangles click into
place. (Never operate apart).
• In the interest of safety, it is not
intended for the tubes to be separated
once assembled.
Remove the fan cover from the side of the sweeper housing by
pressing the spring loaded release button (located on the lower
right side of the sweeper housing) and pulling the cover off (figure
G). Fan cover can be stored in pouch on collection bag.