Advertisement
Tool speed is increased by increasing pres-
sure on the switch trigger. Release the
switch trigger to stop.
Lock-off
button
1 - 1
ASSEMBLY
Installing or removing the saw blade
CAUTIO N
:
*Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the blade.
*Always clean out all chips or foreign matter adhering to the blade, blade clamp and/or
slider. Failure to do so may cause insufficient tightening of the blade, resulting in a seri-
ous injury.
To install the blade, push the push button in the direction of the arrow and insert the blade
between the blade clamp and the slider as far as it will go. Then release the push button
and make sure that the blade cannot be extracted even though you try to pull it out.
CAUTION:
If you release the push button without inserting the blade deep enough, the blade may be
ejected unexpectedly during operation. This can be extremely dangerous.
To remove the blade, push the push button in the direction of the arrow and pull out the
blade.
Blade
Push button
10
Advertisement
