Table of Contents
Advertisement
_Important:
_Important:
_Important:
Setting
the AN
Network
The A/V Network
is a system
that Mitsubishi
developed
to make it
easier to operate
many products
with one remote
control.
When
the A/V Network
is connected
between
two Mitsubishi
products,
you can point the remote
control
at one product
and it will "pass"
the remote
control command
to the other.
To set up the A/V
Network,
follow the steps below.
O Press the MENU button
on the
[]TV
Main Menu
[]
First Time Setup
[]
Customize
Display
[_]
Advanced
Features
_]
Select
A/V Memory
-'<:_ ADJUST
to select
ENTER
to enter
MENU
to exit menus
remote
control.
The Main
[]
Set A!V Network
_off
[]
Basic
ro] Active
_
ADJUST
to select
ENTER
to enter
MENU
to go back
Menu will appear
on the screen.
Use the ADJUST
buttons
to
select "First Time Setup".
Press ENTER.
O Use ADJUST
to select "Set A/V
Network",
then press ENTER.
Use the ADJUST
buttons
to
select "AcrJ_e" ,"Basic", or "Off".
Check the rear terminals
of
your VCR, then use the chart
below to determine
how you
should
set your TV.
Press the ENTER
or MENU
button
to return
to the "First
Time Setup" menu.
Press
HOME to e:dt all menus.
If your VCR has a rear
...and
you have set your
...then
set your TV to:
terminal
that reads:
VCR to:
Basic
AN Network
Active A/V Network
Off
Basic
Active A/V Network
Active
Active
Does not have an A/V
-
Off
Network
rear terminal
If you are not sure how to set your VCR's A/V Network
setting,
refer to your VCR's owner's
guide.
The A/V Network
can still be used to pass remote
control
si_._als
even when the T_s
"A/V Network"
setting
is "()iT'.
If you do not use the A/V Network
system,
set "A/V Network:" to
"Off'.
If you don't, channel
selection
may not work correctly.
If you select the Active or Basic A/V setting,
make sure your
Mitsubishi
VCR with an A/V Network
or Active A/V network
connection
is connected
to Input-1
and the A_
network
cab;_e is in
place.
Getting
Started
57
Advertisement
Table of Contents
