Table of Contents
Advertisement
_Important:
_Important:
_Important:
TV + VCR + antenna
or cable
without
a cable
box
(cont.)
procedure
O
Connect
the incoming
cable or antenna
to the ANTENNA_IN
terminal
on the VCR.
O
Connect
one end of a coaxial cable to the ANTENNA
OUT
terminal
on the VCR.
Connect
the other end of the coaxial cable to the ANT-A termi-
nal on the TV.
O
Connect
an RCA pin-type
video cable to the VIDEO
OUT
terminal
on the back of the VCR. Connect
the other end of this
cable to the VIDEO INPUT
r_erminal on the back of the televi-
sion.
If you are connecting
a Super VHS (S-VHS) VCR, use an S-Video
cable instead
of an RCA pin-type
video cable.
Connect
this S-Video
cable to the S-VIDEO
OUT terminal
on the VCR. Connect
the
other end of this cable to the S-VIDEO
INPUT
terminal
on the
back of the TV.
O
Connect
a set of RCA pin-type
audio cables, to the AUDIO OUT
terminals
on the back of the VCR.
Use the red cable to connect
the right (R) channel
and the white cable for connecting
the left
(L) channel.
Connect
the other
ends of this cable to tile AUDIO INPUT
terminals
on the back of the TV.
If your VCR is monaural
(non-stereo),
you only need to connect
a
single RCA pin-type
audio cable.
Connect
the cable to the VCR,
then connect
the other end to the L (LEFT)
au,iio input
on the back
of the TV.
If your VCR has a video channe!
switch, set it to "OFF/AV".
See
your VCR's owner's guide for details.
Start
playing
a tape on your VCR.
O
Use the INPUT
button
on your TV's remote
control
to select the
correct
input.
If you connected
the VCR tc, INPUT-l,
select
Input-l;
if you connected
the VCR to INPUT-2,
select Input-2.
30
Chapter
2: Connecting
Your TV
Advertisement
Table of Contents
