Makita EBH341R Original Instruction Manual page 11

CONNECTION OF SWITCH CORD
– Connect the switch cords to the two cords from the engine by inserting one
into the other.
– Fix the cord connector by clamp (7).
ADJUSTMENT OF CONTROL CABLE
– Adjust the control cable by adjusting bolt so that it will have 1 to 2 mm play
when the throttle lever is set to the low-speed position by carburetor adjusting
bolt. (Be careful that the cutter blade will not turn in idling.)
Make the throttle wire and I-­O switch cords go along the flexible pipe and fix
three point them on clip wire (8) tightly. If you do not fix the throttle wire and I-­O
switch cords surely, there is fear that they catch on the branch and so on it is
dangerous.
11