Honeywell lynx touch User Manual page 53

9. Select "Stop Zone Type" The system displays
the same options as the previous step.
Note: If a Rule is being used to trigger a Z-Wave door lock,
when the system is Armed Stay or Armed Away, it is
recommended that "End of Exit Delay" be selected for
System Operation 1 or System Operation 2.
10. Select "Start System Operation". The following
options are displayed:
Not Used
Arm Away
Any Burglary Alarm
Bell Timeout
Use the " " " " buttons to scroll to second
page of zone type options.
Start of Entry Delay
Kissoff
System Low Battery
Duress Alarm
11. Select "Stop System Operation". The system
displays the same options as step 10.
12. Select "Zone Number Operation". The system
toggles between the following options:
Not Used
Fault
Trouble
Alarm
Notes: 1. For Fault, the following zone types should not be
used: General Monitor, General Response, Resident
Monitor, and Resident Response.
2. When a zone has been deleted, please verify the
programming selection for Zone Number Operation.
If Trouble, Fault or Alarm is selected, the
system displays several new options. Proceed
to Step 13.
– 53 –
USER FUNCTIONS USER FUNCTIONS USER FUNCTIONS USER FUNCTIONS
Automation
Arm Stay
Disarm
Any Fire Alarm
End of Exit Delay
Chime
Bypass
Reporter Failure