Makita DTD137 Instruction Manual page 9

LED indicator status
012273
NOTE:
When the LED display goes off, the tool is turned
•
off to save the battery power. To check the
remaining battery capacity, slightly pull the switch
trigger.
The LED display goes off approximately one
•
minute after releasing the switch trigger.
When the tool is overheated, the light blinks for
•
one minute, and then the LED display goes off. In
this case, cool down the tool before operating
again.
When the LED display lights up and the tool stops
•
even with a recharged battery cartridge, cool down
the tool fully. If the status will not change, stop
using and have the tool repaired by a Makita local
service center.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only bits that has inserting portion shown in the
figure.
Remaining battery capacity
About 50% or more
About 20% - 50%
About less than 20%
For tool with shallow bit hole
A=12mm Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
A=17mm
To install these types of bits, follow
the procedure (1).
B=14mm
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
011405
Procedure 1
For tool with normal sleeve
1
011406
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
For tool with one-touch type sleeve
To install the bit, insert the bit into the sleeve as far as it will go.
Procedure 2
In addition to the procedure(1) above, insert the bit-
piece into the sleeve with its pointed end facing in.
2
1
011407
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
9
1. Bit
2. Sleeve
2
1. Bit
2. Bit-piece
3. Sleeve
3