Data Equipment; Systems; Automatic Dialers; Toll Restriction And Least Cost Routing Equipment - Cisco SPA 504G Owner's Manual

tification prior to connection. In some states, the state public utility com-
mission, public service commission or corporation commission must
give prior approval of connection.

Data Equipment

The table below shows which jacks are associated with which modes of
operation:
Mode of Operation
Permissive

Systems

Facility Interface Codes (FIC), Service Order Codes (SOC), USOC
Jack Codes and Ringer Equivalence Numbers (REN) are shown in
the table below for each port where applicable:
Port FIC
Line 1 02LS2
Line 2 02LS2
Line 3 02LS2
Phone 02LS2

Automatic Dialers

WHEN PROGRAMMING EMERGENCY NUMBERS AND (OR) MAKING
TEST CALLS TO EMERGENCY NUMBERS:
1. Remain on the line and briefly explain to the dispatcher the reason for
the call.
2. Perform such activities in the off-peak hours, such as early morning or
late evenings.

Toll Restriction and Least Cost Routing Equipment

The software contained in Hosted PBX phone system to allow user access
to the network must be upgraded to recognize newly established
network area codes and exchange codes as they are placed into service.
Failure to upgrade the premises systems or peripheral equipment to
recognize the new codes as they are established will restrict the
customer and the customer's employees from gaining access to the
network and to these codes.

Equal Access Requirements

This equipment is capable of providing users access to interstate
providers of operator services through the use of access codes.
Modification of this equipment by call aggregators to block access dialing
codes is a violation of the Telephone Operator Consumers Act of 1990.

Electrical Safety Advisory

It is strongly suggested that an AC surge arrestor be installed in the AC
outlet to which this equipment is connected.

Radio Interference

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
53
USOC Jack
RJ11C
SOC USOC REN
9.0Y RJ11C 0.1B
9.0Y RJ11C 0.1B
9.0Y RJ11C 0.1B
9.0Y RJ11C 0.1B