Voice-Vlan - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

voice-vlan

voice-vlan VLAN-ID
no voice-vlan
Syntax Description
VLAN-ID
Default
Command Mode
Usage Guideline
Example
Switch(config)#voice-vlan 1000
Switch(config)#end
Switch#
CLI Reference Guide
Use the command to enable the voice VLAN function and to configure a VLAN as
a voice VLAN. Use no form of this command to disable the voice VLAN function.
Specify the ID of the voice VLAN. The valid voice VLAN ID range is from 1 to 4094.
The voice VLAN state is disabled.
Global configuration mode
This command is used to enable the global voice VLAN function and to specify
the voice VLAN on a switch. The switch has only one voice VLAN.
When voice VLAN is enabled, the switch will add a VLAN tag with the specified
voice VLAN ID and the specified priority to the received untagged voice packets.
The received packets are determined as voice packets if the source MAC
addresses of packets comply with the organizationally unique identifier (OUI)
addresses configured by the switch.
The specified voice VLAN does not need to exist to apply the command.
The following example shows how to enable the voice VLAN function and
configure VLAN 1000 as a voice VLAN.
You can verify your settings by entering show vlan voice-vlan command.
voice-vlan
911