Dot1X Pae Authenticator - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

dot1x pae authenticator

dot1x pae authenticator
no dot1x pae
Syntax Description
authenticator
Default
Command Mode
Usage Guideline
Examples
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x pae authenticator
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# no dot1x pae
CLI Reference Guide
Use this command to enable 802.1X authentication on a specific port. Use the no
form of this command to disable 802.1X authentication on the port.
Enable 802.1X authentication on a specific port.
Disabled
Interface configuration
This command is only valid for physical port interface.
Use the dot1x system-auth-control command on page 173 to enable global
802.1x function before enabling 802.1X authentication on a specific port.
A port can be configured as a 1x-enable port only if the port is not a member port
of a port channel, or a destination port of a port mirroring session.
This example shows how to configure port eth4.1 as a 1X-enabled port.
This example shows how to disable 802.1x authentication on port eth4.1.
dot1x pae authenticator
169